- OmsVme58 server update:
- A bug was detected that would cause a motor to move ad infinitum,
if a MoveToCwLimit or MoveToCcwLimit command is started immediately
after a homing procedure.
- The command stop_move, sends a stop command to the motor, even if
the motor is not in the MOVING state
- The function check_motor_registers() never overwrites the controller
register, if the register is non-zero (request by Martin Tolkiehn).
If this happens the user has to decide. Some explanations are
given in the
hardware manual.
- SardanaMonitor Cursor: Widget stays behind SardanaMonitor widget. Status: open.
- LaVue for Pilatus. Implementation will be based on HiDRA. Support is needed. Status: ongoing.
- ICS: replace label 'Terminate the search' by 'Finalize the search', request to MPS. Answer: no new release of the
interlock software until the next shutdown.
- Pilatus external trigger mode: waits only 8 seconds for the next trigger. Request to FS-DS.
- P65 OmsVme58 incidence: motor limits changed after reboot. Observation: limits are shifted by 16 devices,
e.g. from mot17 to mot01. Maybe the effect is related to the Tango configuration (16) and the
shutdown procedure, see below. Status: under investigation.
